A Kind Of Production Line Open Jig Feeding Equipment SolidWorks

1.Manually put the products with protective film and paper into the jig, after putting, manually exit the grating range

2.Manually start the button, the grating will judge whether there is no blocking, in the case of no blocking liner fixed cylinder movement (rotation

pressing); refer to ” 3. X-axis, Y-axis action to the set position, tear tape pre-pressing module recede, Y-axis direction without pre-pressing . 4. Z-axis downward action to the predetermined position, the clamping tape sheet into the clamping position. The cylinder clamps the tape, the pressing module presses the protective film, the tearing tape Z-axis slowly moves up, Y-axis slowly moves, A-axis rotates about 90??, X-axis moves to throw down the tape to the recycling box

5, according to the parameters (position, quantity), repeat 3-5 steps to complete the current direction of the set number of tearing tape .

6. Z-axis return, tearing module and pressing module rotate 90??

7. X-axis and Y-axis move to set position, Z-axis move to predetermined position

8. 8?€?Tear tape X-axis pre-pressing module to the set position, pre-pressing on the protective film in X-axis direction

9?€?According to the parameters (position, quantity), repeat 4 steps to complete the number of tear tape set in the current direction;

10?€?Y-axis action to the pick and place material position

11, the product to manual pick-up position, liner fixed cylinder back to position, tear the product after the protective film.