U-Shaped Screw Feeder SolidWorks

Screw conveyor technical requirements

1?€?The bearing seats at both ends of the box, the journals at both ends of the spiral shaft and the bearings must be concentric, and the spiral shaft rotates easily without sweeping.

2?€?The inside of the box body and the shaft (including the blade) should be sandblasted to remove the oxide skin, after which two coats of epoxy resin should be applied.

3, the box and cover and other general external surface should be sandblasted to remove rust and then spray paint.

4, each rubber pad should be strongly glued to the box.

5, all fastening coupling standard parts are suitable for the purchase of galvanized passivation treatment standard parts.

6, wheel cover with legs fixed as appropriate.

7, packing pre-pressure moderate, not too tight, no leakage of powder.