Automatic Stator Shaft Assembly Line, Large Non-Standard Assembly Line SolidWorks, 3D Exported

Automatic stator shaft assembly line, the model contains engineering drawings, and list bom is a large non-standard assembly line, automated non-standard assembly line assembly of various complex parts.
Non-standard automatic production line automatic stator shaft assembly line working principle and action sequence:

A. Special tooling plate from the lifting platform into the tooling plate stack storage area.

B. When the tooling plate for BMC stator is empty, the tooling plate enters the work station from the stacking area. (The blocker blocks the plate and the plate stops, same below.) The robot will put the BMC stator (2 sets in total) into the corresponding position of the special plate, step down the foot switch, and the plate will go down and enter the next stacking area.

C. When placing the rotor, PG plate and BB cover work station is empty, the tooling board will automatically enter the work station, then step on the foot switch, the tooling board will automatically run to the next work station staging area.

D. When the BB cover press station is empty, the tooling board automatically enters the station and automatically presses the BB cover to detect the tampering amount, etc. After pressing, the foot pedal switch is pressed and the tooling board automatically runs to the next station for storing.

E. When the performance testing station is empty, the tooling board will automatically run to this station to detect the performance manually, after the performance testing is finished, then step on the foot switch, the tooling board will automatically run to the tooling board lifting platform stack storage area.

F. Execute the next cycle. 3, The total length of the line body is 5 meters (including the lifting table at both ends) (subject to actual design), the total width is 300 mm (subject to design size) (excluding the protruding part of the lifting table at both ends), the height of the upper layer containing the workpiece plate is 800 mm (subject to actual design), and the height between the two layers is 400 mm (subject to actual design). The height of the support stand of the line body is adjustable within ??30mm.

4. The line body adopts double layer back to the plate structure, the upper layer is for the motor transmission, and the lower layer is for the rapid return to the plate for the tooling plate.

a. The line body is driven by roller chain; driven by independent power.